Skip to toolbar

1:56 Scale Leopard 2A5 3D print

Supported by (Turn Off)

Project Blog by bloodstrike Cult of Games Member

Recommendations: 16

About the Project

Urge to have a 28mm scale modern Tank of some kind. potential to add to a modern army when I get around to picking up some infantry for the era.

This Project is Active

Leopard Hull Print

Tutoring 2
Skill 3
Idea 3
1 Comment

Hull Print is still in progress with around 12 hours left to finish. temperature slightly higher and from what is visible currently looks much better than the turret.

2A5 Turret print 1

Tutoring 2
Skill 3
Idea 3
No Comments

size restrictions on my printer require this entire tank to be printed at a 45 degree angle which creates a lot of waste and long print times. overall the print had some layer adhesion problems from low temperatures going to use this to test out paint schemes and experiment with some stowage addons.

Supported by (Turn Off)