GameCraft Plan The Building Of A Neat 20mm Indian Temple
March 16, 2015 by brennon
20mm Indian Temple In The Works
GameCraft have put together a little preview showing off the work that's going into making a 20mm Indian Temple that could also work in a Middle Eastern setting too. Check it out...
It's quite an impressive set piece as it stands but with a few additional walls done in the style of that front one you can see above you'd have a very cool looking objective for the middle of the table. As well as being in 20mm scale they're also working on a 15mm and 6mm version too.
I could really see a unit of soldiers holding out within its walls and having to figure out when to redeploy to the different sides as masses of enemies roll in around them. It would make for a great last stand!
If That's Not Enough Also Check Out The Oil Derrick
As well as the luxury and epic design of an Indian Temple they've also got this very practical and down to earth Oil Derrick that you can use in your 15mm gaming. Pick up a few of these and weather them down, stick them in a big desert landscape, and you've got the makings of an epic table once more.
The tower itself gives you plenty of scope for snipers and spotters for artillery as armies fight it out below on the sands. It seems like it would work perfectly for battles in the Gulf.
What do you make of these pieces?
"I could really see a unit of soldiers holding out within its walls and having to figure out when to redeploy to the different sides as masses of enemies roll in around them"
Supported by (Turn Off)
Supported by (Turn Off)
"The tower itself gives you plenty of scope for snipers and spotters for artillery as armies fight it out below on the sands"
Supported by (Turn Off)
That temple would go well with some of 4Ground’s new Arab Rural Houses. 🙂
Slightly different scale I think
You could possibly get away with using it alongside the 28mm stuff in its 20mm scale – possibly. You’d have to size them up against each other and see if it works. The Temple might be a tad too small though.
BoW Ben
Ben, I think you are right. A 25mm round base will just fit within a square inch (I’m assuming those are inches on the cutting mat in the picture). The model shown is the 15mm version (there’s a bigger picture on the FB page with both the 20mm and 15mm side-by-side). Either way the doorways will be a bit too small for a figure on a 25mm base. I guess one could cut the doorways a bit wider.