Hobby Lab: Winterdale Watchtower 4, Filling
June 26, 2019 by johnlyons
Now that the towers parts have been prepped, we can address the small flaws in the print.
Using some Milliput we will tackle the print errors on one section of the tower. This is a two-part putty that can be made more fluid by adding water. A little bit like clay.
Using a craft knife, or sculpting tool (if you have one to hand) we can fill the stonework and make it level again.
Once all the areas we want to fill are done, we can use the craft knife, or sculpting tool, to redraw in any lines that we have have filled by accident. After this is done we have to leave the Milliput to set for about four hours, or oivernight.
