Full Spectrum Dominance CitizenCon Project

Supported by (Turn Off)

Project Entry by deltex

#UPDATE 3 - Magnets and Priming

November 17, 2024

Tutoring 3

Skill 3

Idea 3

2 Comments

Once all the magnets were superglued into the bases I then also glued smaller 2mm x 1mm magnets into the turrets and vehicles for the enlisted units.

It was now time to prime, starting with black primer.
I had an old large metal ruler so stuck most of the models on both sides and hung it up for easy spraying.

Then, a zenithal highlight of white was sprayed from above the models to help pre-shade.

2

Leave a Reply

newest oldest most voted

2032xp

avien

Been looking at FSD for a while but I’ve so many projects in the queue for the resin printer that I can’t bring myself to add a whole new game!

Great to see some real prints of the stuff here, they look like they came out super clean.

I feel the same about the bases, I’ve been printing a lot of 8mm stuff lately and the bases supplied are always crazy big

Author

30xp

deltex

Yeah, the pre-supported files printed really well apart from a few slight issues I had.
1. Had to cure the infantry models then used clippers to cut the supports away carefully, as the legs snapped off before curing sometimes.
2. The support legs on the Enlisted Self-Propelled gun was a nightmare. again, had to cure then carefully clip the supports away. Ended up printing about six Self-Propelled guns to get two that were useable.
3. The Enlisted Gunner and Support Walkers love to snap at the knees, but that can be fixed with superglue.