To the Trenches! Chain of Command
How its done .... ground texture
I didnt really take any photos of this process, but the paste was then simply spread on using a lolly pop stick, and in the areas close to any of the woodworks, I used a sculpting tool.
When this had been applied, I waited an hour and then used a stiff thistled brush and then dampened and tapped down onto the ground to give it a rougher texture/appearance.
Its also worth pointing out, that the small wire lines at the front of each piece, were pre-laid out prior to adding the ground mix, and then once the mix was applied, the posts and wire were added in while all still wet – this meant the filler would essentially help hold it all in place.
Leave a Reply