Skip to toolbar
Designing a new game with accompanying model range from scratch

Designing a new game with accompanying model range from scratch

Supported by (Turn Off)

The first printing

Tutoring 5
Skill 6
Idea 6
No Comments

So this didn’t go as well as I’d hoped. The blades are WAY too thin and most of them snapped off. The regular dogs need to be reorientated as they didn’t print right on their butts. Strangely, the cats came off the best, with only one of the blades snapping (because of my fat fingers) but they were a bit small and fragile. The Labrador knight was a disaster, his cloak was too thin and I accidentally snapped his right arm whilst trimming off support I’d missed. It’s a learning curve, and I feel I learned a lot from this first run.

I’ll thicken up the blades and then re-size the models in 3D builder to reduce their flimsiness, so stay tuned.

Leave a Reply

Supported by (Turn Off)