Dystopian wars table, terrain and fleets
The terrain journey continues
nothing fancy just a few 3D printed pieces finished off with basic modelling stuff.
The ice and snow effect was achieved simply using a white undercoat then a thinned blue wash, then a heavy drybrush with a brilliant white. At this point they still dont look right but dont worry they get better.
i used a wire cake rack suspended over a baking tray for the next part. Apply PVA glue all over place on the rack and give a good coat of snow flock , once dry apply a good coat of gloss varnish from a spray can then whilst sitting on the cake rack dust with a 50/50 mix of snow flock and polyfilla powder. when dry its a simple case then of spray and dust until you get your desired finish.
Leave a Reply