No Cows Here!
Elven Archers
Hi everyone,
During the week I was working on the archers and another unit type for the army, so I bit off a bit more than I could chew, but I managed nonetheless to finish these archer companies.
I went with four columns to make then less compact than the spears.These elves come in sprues of two – usually attached – but I found that two on a 40mm x 40mm base seemed a bit empty (even though they are representational).
Therefore, like the Shadow Warriors in the previous post, I cut up some more, patched them up and added another rank. I later found out that you can buy 3d print elven archer in singles off Ebay! Just my luck!
Adding another rank helps fill the base out more.
Overall I think they look better with three ranks than two.That is all for today, next week there be dragons a flight!
Until then stay safe and have fun.
NR
Leave a Reply