converting a toy helicarrier
dry fitting parts
so for the hull of the hellicarrier i needed to dry fit the parts to make sure I had enough armor plating and to also make sure that the armor plating would fit. I will need to extend the frame a bit so that I can squeeze one more plate in. I have printed the engine as well so in total it will be around 2ft 5in around about that. once that is done it will be time to super glue for the quick hold, then to use gorilla glue for a sturdy hold. after the frame is all glued down it will be on to flooring and side panel walls to hide all the mess. I am thinking of adding some sort of wiring for the engine just to make it look a bit more busy.
Leave a Reply