Building into space
Deck 9
I have downloaded a different profile for the slicer and I cant believe the difference, the overhang on the right is printed with supports on the standard profile, the one on the left is printed with the profile 2nd Dynasty have a link to in their instructions without supports.
I didn’t think the settings in the slicer could make that much of a difference!
And may I ask what printer/slicer/filament you’re using?
I am using a Prusa i3 Mk2S and the PrusaSlicer (although I was using Cura until recently) and the filament is AnyCubic PLA (grey). I’ve only just started using the AnyCubic filament as previously I used PrimaValue but that doesnt seem to be on amazon at the moment.
You’re getting good results there! I need to check the profile you’ve mentioned.
BTW, try prusament some time, the price is higher but the stuff is good quality and Slicer is well acquainted with its features.
Thanks, I have been looking at their stuff but the shipping to the UK is nearly the cost of a spool of filament, maybe when I’m ordering load I’ll get some.