Grey Knight Nemesis Dreadknight Spiced Up (Spring Clean)
3D Prints and Basing
3D printed a couple rocks to make the base a bit more visually interesting. I originally planned to have two bloodletters leaping off the rocks, but one of them was a little smaller than anticipated, so only one will be standing on a rock. I think I prefer it this way though, as it makes the base more visually varried.
I then put some PVA glue mixed 1:1 with water on the base, and sprinkled some baking soda over the base to give it texture. Once that dried, I used an old brush of mine to knock the loose baking soda off the base. There are a few other bits that I’ll put on the base, but I’ll paint them separately then glue them on. Next up, I’ll prime everything, likely a black, then its on to the painting!
Leave a Reply