Digital dice roller
Fitting it all together
Speaking of enclosures, after a quick rinse and final cure, my first three enclosures were ready.
Everything looks quite promising at this early stage….
….but I’ve yet to work out what happened to my letter ‘E’ or the OTT logo? Maybe there were some inverted normals or something?
I’ll have to get those sorted out before the next print run! In the meantime, I might try painting them in on these and hope nobody notices!
One thing I hadn’t noticed was that a lot of phone chargers now have quite chunky plugs on the micro USB end. And I’d only allowed for a small hole on the side of the enclosure to plug the charger into. I needed to modify the battery charger so that the micro USB plug didn’t sit “behind” the wall of resin, so that a charger would actually plug into the socket.
A bit of clumsy knife-work and a bit of filing later, and it was a nice, snug fit.
The little lip I left in the bottom of the enclosure….
….seats the piezo sensor just perfectly!
Leave a Reply