Skip to toolbar
Grey Knight Nemesis Dreadknight Spiced Up (Spring Clean)

Grey Knight Nemesis Dreadknight Spiced Up (Spring Clean)

Supported by (Turn Off)

Reposes Done, and Some Battle Damage!

Tutoring 10
Skill 10
Idea 10
No Comments

Reposed the Daemons so they more organically fit into their positions, also added bullet wounds/damage to the charging bloodletters, as well as claw and sword gouges on the Dreadknight’s hull. Did this with a combination of careful hobby knife work and a hand drill (stay safe, always cut away from yourself and other people). For reposing the daemons’ limbs, I sliced them at a joint then carefully shaved off plastic at an appropriate angle to reposition the limb as desired. For the bullet wounds and gouges, I used the drill and knife to create a pockmarked surface. Next up, I’ll put the base together with a few 3D printed rocks and my baking soda method for texturing bases, gore, wounds, and dirt on vehicles.

Here’s another few mock-ups using poster putty and the newly posed and damaged models. I got some measurements for how much to raise each daemon and foot by off the base, so I’ll be 3D printing those pieces over the next week!

Leave a Reply

Supported by (Turn Off)