Skip to toolbar
Dan's 3D printing

Dan's 3D printing

Supported by (Turn Off)

Winterproofing my 3D printer - part 3

Tutoring 2
Skill 2
Idea 2
No Comments

I’ve had several successful prints now so I’m going to call my winterproofing a success. My garage is cold enough that I can see my breath, so only a few degrees Celsius. The temperature inside by foam box is 10 degrees, but the mat is 30 degrees. The heat must be passing up through the heater and warming the resin bath effectively.

Leave a Reply

Supported by (Turn Off)