Skip to toolbar
Dan's 3D printing

Dan's 3D printing

Supported by (Turn Off)

Winterproofing my 3D printer - part 2

Tutoring 2
Skill 2
Idea 2
No Comments
Winterproofing my 3D printer - part 2

Well it seems the reptile heating mat worked. I left the printer running over night. The weather got particularly frosty that day but the print did not suffer from the resin curing problem again.

 

The print did fail but the cause was the print sticking to a damaged part of the FEP film. When I tried to scrape it off the film actually tore open. It wasn’t until this weekend that I had the time to replace the film and get the printer up an running again.

Leave a Reply

Supported by (Turn Off)