Red Rocket 3D Printed
A whole lotta' roofin' going on - Part two
Welcome back all.
On with the roofs.
Starting with this roof (which required a small support on the rear tab).
Next comes one of the rear roofs that will attach to the building roof. This (and the next roof) angle about 5 degrees towards the back, so that the entire canopy will slope back towards the building.
And here is the last roof for the canopy section.
So, there are all of the the canopy roof parts. Put together they look like below (the total length of this canopy is 18″/46cm or 19″/48.5cm if you include the rear left tab.
The next blog post will show the roof sections for the top of the building.
Catch you later folks.
Leave a Reply