Skip to toolbar
Red Rocket 3D Printed

Red Rocket 3D Printed

Supported by (Turn Off)

Fixing the Un-fixable

Tutoring 4
Skill 4
Idea 4
No Comments

Despite my best efforts I have not been able to get the Girder B to print without failing.

There are two options here.

First is to continue on in the hope that it will eventually print out.

The second, find a work around and here it is…

Fixing the Un-fixable

I have decided that in order to progress with this build I would print the upper section out separately, then glue them together.

I will go into details in the next post As I will be using the same technique to print the roof sections and assemble them.

I have, however, not been idle, below are the Billboards.

Fixing the Un-fixable
Fixing the Un-fixable
Fixing the Un-fixable

As mentioned before, these are Available from Printable Scenery.

Two of these were printed in a 0.25mm layer height and scaled to fit the Printed Billboard Posters.

I have also Started Printing the Roof Sections and I will follow with another blog in a few days time.

I haven’t forgotten the Red Rocket Signs, I will return to them later on.

Until next time folks.

Leave a Reply

Supported by (Turn Off)