Skip to toolbar
Red Rocket 3D Printed

Red Rocket 3D Printed

Supported by (Turn Off)

Herbie Hancock move over

Tutoring 7
Skill 7
Idea 8
No Comments

So the Canopies and Pumps printed fairly well. Once I’ve cleaned them up they will be done. (Nurgles Servants Spread the word. The word being ‘Plague’ ).

Herbie Hancock move over

Now comes the part that I’ve been looking forward to print the most… Yup it’s the Red Rocket itself.

Herbie Hancock move over

This is one big model coming in at just over 174mm tall.

This model is going to be printed at .25mm Layer height and using a Brim.

The supports will be added to each of the Rockets engines (two rectangular supports and one square support for the bottom of the rocket.

Herbie Hancock move over

Really looking forward to see this model in the flesh (so to speak).

Back soon folks.

Leave a Reply

Supported by (Turn Off)