Skip to toolbar
Build an LED Arch Hobby Light

Build an LED Arch Hobby Light

Supported by (Turn Off)

Working in the slicer

Tutoring 1
Skill 0
Idea 0
No Comments

When I initially built the model the part that slides under the table was a good bit longer, but upon slicing I saw it had become a 14hr print. (resin printers time is based on the height of the model).

I thought that was overkill and the way the forces would act upon the clamp it wouldn’t be necessary so I tweaked the model and what you see here is about a 7hr print (per clamp.)

Working in the slicer
Working in the slicer

You will notice some little holes in the clamp. I added these to run some of the electrical components through.

Leave a Reply

Supported by (Turn Off)