Skip to toolbar
Build an LED Arch Hobby Light

Build an LED Arch Hobby Light

Supported by (Turn Off)

Building some supports in.

Tutoring 1
Skill 0
Idea 0
No Comments
Building some supports in.

When printing this on the resin printer there will be a part that will need a few extra supports to stop it collapsing in on itself during printing. Rather than messing around with the slicer I just added 1.5mm pillars (Marked in orange) to that section in the model. If it works I will then basically scrape these bits out after it prints.

Leave a Reply

Supported by (Turn Off)