I want to stay at the J - S - D - F
3D printing
Getting ready to 3d print my new files, I load up my slicer program, ChituBox and import the files, sometime’s I’ll angle the mini’s and sometimes I keep them upright, all depends on if which I think will print the best. Below you can see, the imported file, before and after supports and my support setings
NOTE: not the original lot as hadn't thought of making a project for this at the time,
After slicing and saving the file to a memory stick, it’s time to turn on the printer, pour in some resin and press print…. the print as pictured will take about 3hours and 6 minutes, but the first one I did took about 2hrs45, but they were upright and had some slight fails.
Leave a Reply