Skip to toolbar
1/200 Scale Japanese Destroyer 3D Print Project

1/200 Scale Japanese Destroyer 3D Print Project

Supported by (Turn Off)

Back to the bow section...

Tutoring 0
Skill 1
Idea 1
No Comments

Alright…  So upon further inspection, I decided to revisit the bow section in TinkerCad.

I went ahead and removed the antenna(?) structure at the very nose…  It didn’t print well anyway.  Then I thickened up the shafts of the anchors that go into the ship.  They were quite thin in the first print and just bound to break off.  Also, I believe that the anchors will print a little better now.

Next, I added some rectangular structures to the deck to camouflage some weirdness in the file.

I will export the updated version to my computer as an STL file and then pop it into Chi Tu Box to get it ready to print.

 

The red boxes are structures I have added to conceal weird angles in the file.  The gray box is a The red boxes are structures I have added to conceal weird angles in the file. The gray box is a "hole" that will remove the antenna structure.

Leave a Reply

Supported by (Turn Off)