1/200 Scale Japanese Destroyer 3D Print Project
First Test Print
Ok, after a failed print due to a power outage at the worst possible time, I have the first test print of the bow section.
Overall, I am fairly satisfied with the print. I printed this with no supports, it looks like the anchors warped a bit and probably should have been supported.
I also got some odd flaws on the deck. I will be taking a closer look at the print file to make sure there isn’t any gapping that I didn’t notice. I suspect that the LED screen in my printer may be failing. They do wear out and mine has had quite a lot of prints run through it. Fortunately, I have planned ahead and have a spare screen on the shelf ready to go if needed.
Leave a Reply