Skip to toolbar
Getting Zona Alfa to the tabbletop

Getting Zona Alfa to the tabbletop

Supported by (Turn Off)

Models based

Tutoring 7
Skill 5
Idea 6
No Comments

Went with sand & gravel, painted thinned down pva to the bases, stuck the models into a mixture of sand and gravel, tapped off anything loose and tidied up the edges and left to dry.

After they’d dried any obvious patches were re-covered and left to dry. finally a mix of 50/50 water & pva with a drop of washing up liquid to reduce surface tension was layered over all the sand and gravel and left to dry overnight.

Models based

Leave a Reply

Supported by (Turn Off)