Getting Started with Adeptus Titanicus...
Howie did it.... again...
With magnetising the weapons I used a slightly different message to the one earlier in this Projeect.
I still drilled the holes as normal but with trying to drill on a round surface the bit sometimes slips and the start hole is too large to grip.
Normally some super glue would sort that out but I’d run out (shame!)
I discovered on something else I was working on that if there’s a slight ridge or so above the level of the magnet that a drop of poly cement will part melt the plastic and using a wooden spatula you can “bend” the edges over to help seal the magnet in place.
Failing that, some of the filings from the hole can be glued over then trimmed and filed to help nip the magnet.
Leave a Reply