Blipvertus multigame Dwarf army
Flags!
Well, just the one flag. After cutting the flag out I used a plain sheet of white stationery and cut it slightly larger than the transfer. 
I then peeled off the plastic cover and applied the transfer face down pressing it firmly onto the paper. I then wetted the back of the transfer sheet and peeled it off. I then left this alone until it was dry. 
I then trimmed the paper as closely as possible to the transfer using the smallest pair of scissors I could find. I then pre shaped the flag by wrapping it around some paint brush handles. 
I then used Elmer’s glue thinned slightly with water then throughly covered the back with a brush. I then wrapped the flag around the banner pole and lined up the edges and shaped the flag, again using a pair brush handle. Once the flag had dried, I painted the edges where white was showing with Vallejo Prussian Blue or Army Painter Plate Mail Metal.
With everything now done, I sprayed all the spearmen and the banner bearer with Army Painter with Anti Shine Matt Varnish. 
Leave a Reply