Skip to toolbar
Blipvertus multigame Dwarf army

Blipvertus multigame Dwarf army

Supported by (Turn Off)

Adding a banner Part 3

Tutoring 3
Skill 4
Idea 1
No Comments
Once dry, trim the paper as close as possible to the transfer. Once dry, trim the paper as close as possible to the transfer.
Pre-form the transfer by wrapping it around the banner pole. Pre-form the transfer by wrapping it around the banner pole.
Coat the paper with glue, I used Elmer’s Glue, then wrap the transfer around the pole. Carefully align the edges before the glue sets. Coat the paper with glue, I used Elmer’s Glue, then wrap the transfer around the pole. Carefully align the edges before the glue sets.

While the glue is still wet, use either a paint brush handle or small wooden dowel to add a wavy appearance to the banner.  Do this by wrapping the banner around it.

Let the glue dry, trim again if necessary. Paint the edges too. I used Vallejo Ghost Grey on the edges.

Leave a Reply

Supported by (Turn Off)