Flames of War: 3D Printing Amphibious Craft and Ships

Flames of War: 3D Printing Amphibious Craft and Ships

Supported by (Turn Off)

Project Entry by templar007

Back to Project Blog

The first Higgins boat is 3D printed!

September 22, 2019

1 Comment

I think it was a success! I printed it at 0.1mm layer height and 25% fill. I found the model on 'Thingiverse' and the published creator of the model is listed as 'ChillyT'. When I downloaded the model it was in 28mm scale. Pretty simple to change the scale to 15mm. Next up to print the small fiddly bits!

I think it was a success! I printed it at 0.1mm layer height and 25% fill. I found the model on 'Thingiverse' and the published creator of the model is listed as 'ChillyT'. When I downloaded the model it was in 28mm scale. Pretty simple to change the scale to 15mm. Next up to print the small fiddly bits!

1

Leave a Reply

newest oldest most voted

Guest

0xp

Robert

Good stuff. Will be interesting to see how this progresses. Thanks for sharing.