Building a pub interior by Jo from Oathsworn
Part 5
The next job was to make the bar area which is L-shaped and must be accessible to all minis in the game, so a 50mm base must fit easily around it. I grabbed a few minis of various sizes and played about with foam until I felt that there was a variety of heights suitable for the different minis (you don’t want to stop the Shrew-zerker from getting his pint coz he can’t reach the counter…it won’t end well!).
I glued the various piles of foam together.
To hide the obvious layers of foam I needed some side pieces, so I placed the piles together onto some 3mm foam, drew around them and cut them out.
I then glued the piles together and stuck the sides on holding them in place with a few pins. They were then left to dry overnight.
Using my bic pen I then added some wood-grain details all over the bar.
I then stuck the bar in position with PVA glue and weighed it down (with actual weights this time) overnight while it dried.
Leave a Reply