Skip to toolbar

Taking the plunge with a 3D Print

Supported by (Turn Off)

Introduction

Tutoring 1
Skill 2
Idea 2
No Comments

I always set out to get a printer to do terrain. Well that and to give me the ability to print out simple toys and such like for my toddler.

However my 3D design skills are non-existent, after a foray into creating a replica of a shower fitting that had broken, which worked and got me loads of good husband points in the bank, I really only did basic shapes to make my own templates and tokens for a few games.

Upon discovering Moonstone the urge to create my own town in the world has pushed me to try a bigger printing project.

I have been reticent in the past as I am not 100% sure on how good I have set up the printer and have been worried that it would not work, however I heard good things about the printable scenery guys, so backed their recent kickstarter for some Dwarven buildings, that would also work for when I get my Fabled Realms KS through.

This is a quick project to document start to painted finish of the basic dwarf house.

Leave a Reply

Supported by (Turn Off)