Skip to toolbar
3D models and Prints of Ships for Darkstar

3D models and Prints of Ships for Darkstar

Supported by (Turn Off)

Valcour Class Destroyer

Tutoring 0
Skill 1
Idea 3
No Comments

3D Model

3D Print

Valcour Class completed as first ship with multiple parts other then the weapons. the top of the tower section on the ship is a separate part to avoid the scaring on the top of the hull from support. First print of the ship actually collapsed when Cura failed to put any support under the two wings at the back of the ship after a few setting  changes it ended up printing correctly

Next Steps

going to need to start organizing all the part files created so far into folders this weekend it is starting to get out of hand dumping everything into my 3D object folder. see below for the new Endeavor if it survives printing will have the next update with it tomorrow night.

New Endeavor - built in two halves will see how it turns out once printedNew Endeavor - built in two halves will see how it turns out once printed

Leave a Reply

Supported by (Turn Off)