Skip to toolbar
Necromunda: The Halls of Hive Primus

Necromunda: The Halls of Hive Primus

Supported by (Turn Off)

In the beginning there were cardboard tiles...

Tutoring 9
Skill 10
Idea 13
No Comments

To start things off i needed to know what i was going to work with, since the underhive box set came with a selection of pre-printed board tiles i decided that it would be best to use them as my starting point.

In the beginning there were cardboard tiles...

Luckily for me boards were already divided into quadrants 6 squares wide and 6 squares long.

Using these dimensions I drafted up an idea, 2 square MDF boards, the upper layer being a grid with 36 holes and the lower layer being a standard flat board for everything to rest on and provide stability.Using these dimensions I drafted up an idea, 2 square MDF boards, the upper layer being a grid with 36 holes and the lower layer being a standard flat board for everything to rest on and provide stability.
The initial board, the starting point for the rest of this project.The initial board, the starting point for the rest of this project.
The last piece of the board would be the tiles, using the cut-outs from the upper layer each of the 36 tiles were engraved with a border or a drain to break up the flat areas and to make them a bit more interesting to look at.The last piece of the board would be the tiles, using the cut-outs from the upper layer each of the 36 tiles were engraved with a border or a drain to break up the flat areas and to make them a bit more interesting to look at.

Leave a Reply

Supported by (Turn Off)