Skip to toolbar
Amon Hen: Middle Earth SBG Terrain.

Amon Hen: Middle Earth SBG Terrain.

Supported by (Turn Off)

Stupid...Fat....hoBbit's!

Tutoring 0
Skill 0
Idea 3
No Comments
Stupid...Fat....hoBbit's!

Yup…ran out of filament during the print.

The good news! The stone work looks good. Very subtle and the very few layer lines that you can see plays in well with Stone brick.

Oh I should of mentioned this. Most people tend to print at .1 mm layer heights with terrain. It speeds up the print process but the trade off is more noticeable layer lines.

I normally print at .08 mm layer heights. It may add a few hours to a project. But if you are already printing something for 6 hours at .1 mm what’s an extra hour at .08 mm. My CR-10 and Monoprice Mini can both hand layer heights down to .04 mm with out an issue. So .08 mm isn’t over tasking them.

Well 3D printer has been reload with filament and currently redoing the test print. It should be done close to 8pm (7am currently as I write this). It may go over in time, those slicer programs always under estimate the print times.

 

 

Leave a Reply

Supported by (Turn Off)