Skip to toolbar

Dropzone Commander - Scourge

Supported by (Turn Off)

Step 2 - Spraying Vehicle tops

Tutoring 1
Skill 0
Idea 0
No Comments

This step was nice and simple while the PVA was drying I took the opportunity to spray the vehicles specifically the top and sides.

I used PlastiCote White Primer. I have found this to be a good spray and a little more reliable than the Poundland specials which I have had a few dodgy nozzle’s and such.

Remember when spraying to always for the following warm the can – warm (not boiling) water or back pocket for a bit, shake for about 2 mins and make sure it’s not to hot,cold,windy or humid and always do a test spray on a bit of sprue or some such

Leave a Reply

Supported by (Turn Off)