Skip to toolbar
Terrain Challenge: Summoning Portal

Terrain Challenge: Summoning Portal

Supported by (Turn Off)

Part 12 - Putting it Together

Tutoring 4
Skill 6
Idea 5
2 Comments

Final stage was to redo the portal. this was essentially actioned in the same manner as my first attempt, only once assembled I used a hot glue gun to affix the component demon in place on the front of the portal.  This would allow me to target the ink in specific locations.

Part 12 - Putting it Together
Part 12 - Putting it Together

Once this had been completed I used ink starting with red over the back of the parts where the demon was stepping through and shaded down with orange and then yellow outwards until the perspex was covered sufficiently. I then touched up the outside with a mix of yellow ink and yellow paint to add some extra brightness.

Part 12 - Putting it Together

Portal without the demon was easier – i just started with a random blob shape in the centre of the perspex in red and built out form there. Once both had dried I touched up any gaps that had opened in the ink covering with a second layering of ink.

Part 12 - Putting it Together

2
Leave a Reply

1 Comment threads
1 Thread replies
2 Followers
 
Most reacted comment
Hottest comment thread
2 Comment authors
evilstulancorz Recent comment authors
newest oldest most voted
lancorz
Member
5700xp

This is such a cool idea, loving the demon appearing out of it!

Supported by (Turn Off)