Skip to toolbar
Levarius' Army of the Dead - Middle Earth Strategy Battle Game

Levarius' Army of the Dead - Middle Earth Strategy Battle Game

Supported by (Turn Off)

Adding the Oxide - Part 2

Tutoring 9
Skill 10
Idea 10
No Comments

After painting about 8-9 of them, I realised that the blue might be a bit too heavy and overpowering,  especially when the oxide paint drys and stops being so translucent.

Therefore, for the rest of the models, I opted to mix in some Lahmian Medium to reduce the thickness of the blue. After doing a further few models, I think that in the end the ratio was along the lines of 1:1, though I can’t be exact as it was slightly different each time!

I went for rough mix of 1:1 between the Nihilakh Oxide and Lahmian MediumI went for rough mix of 1:1 between the Nihilakh Oxide and Lahmian Medium

Above shows some of the models with a lighter tint of blue, which I think works better. I was worried at this point that I would have to repaint all the ones done with the heavier blue. However, when I put them in a big group, the differing shades of blue works really well when all mixed together. That’s a relief!

Adding the Oxide - Part 2

The next entry will be focused on the edge highlighting and starting the bases, stay tuned.

Leave a Reply

Supported by (Turn Off)