Warhammer 40k, Imperial Grey Kinght
Part 9, beginning work on legs
The legs hear are a bit of a problem for me. I need to basically double the length if not nearly triple the length of the legs. So what I did was I chop the legs up into three different pieces. In between the hip and the knee I cut it roughly in half. Then I cut the knee the bottom part of the leg off. And I put the shin part to the side. And begin measuring the length that I needed the the hip and elbow to be. I’m going with roughly an inch.
So I cut a piece of styrene to be 2″ by about half a centimeter. And then I cut a piece of tube styrene to be 2″. Then with the flat piece of styrene I glued it onto the back side of the hip. For it will be flush with it. I repeated the process on the other leg and then came back to this one and glued the tube on to the styrene for support. I’m marked where an inch would be from the cut of the hip to where would end up on the styrene. And then tried my best to glue the knee on that line.
Leave a Reply