3D printing with janus1004

3D printing with janus1004

Supported by (Turn Off)

Project Entry by janus1004

Back to Project Blog

Next Entry >>

<< Previous Entry

Printable Scenery - Tribal fence and two scatter pieces from the "Lost Islands" Kickstarter

June 26, 2018

No Comments

The leftmost piece is printed with 0.05mm, the other two using 0.1mm. As the piece is quite small it could be worth the time printing it with the highest resolution. The painting was done with as much airbrush as possible to get shading and such, ropes were washed using Army Painter Strong tone. A quick job, but very functional models.

The leftmost piece is printed with 0.05mm, the other two using 0.1mm. As the piece is quite small it could be worth the time printing it with the highest resolution. The painting was done with as much airbrush as possible to get shading and such, ropes were washed using Army Painter Strong tone. A quick job, but very functional models.

Leave a Reply