Collins does a Frostgrave board
replaced the piss take hill
Ok so i decided i should use the last tile and i had some modelling compound left over.
simple low rise hill thats been reinforced with wooden planking. It’ll be enough to allow an archer to shoot over the walls of the cemetery without a cover save but thats it. It is also wide enough for a small ruined building to be added at a later date if i can be bothered.
slapped on a load of modelling compound and agitated into position. then i pushed in a load of coffee stirrers and let it set. once dry i removed the coffee stirrers, painted the hill white and cut up the coffee stirrers into smaller planks.
the small planks were then superglued back onto the side of the embankment and big long matches cut down to pole size and superglued down in a rough and ready fashion. i knew i wasnt going to paint the planking or stain it so i was less than careful with the superglue application.
then PVA’d the whole thing and gave a liberal sprinkling of snow flock. Done
Leave a Reply