Building the Old West
Changed my mind
And of course like any port, I changed my mind after thinking about things. I’ve decided to go ahead and get some of the Sarissa Precision downloads and print out some brick and flooring patterns.
After printing out the brick pattern, I just cut out a section slightly larger than the wall by holding the wall up against the paper and then just trimming it down. 
I then covered the interior with PVA glue. 
I then lined up a line of the brick work to the top of the wall so that about one layer of brick is above the wall. I then slowly rolled the paper out and the vigorously scrubbed out any air bubbles. I had to do this several times. 
Exterior side of the wall. I’ll let everything dry and trim everything down later. 
One of the other walls. I’ll add wood planking to the buff area later. 
This is the opposite wall that has a door detail on the exterior. This door frame is actually supposed to go on the outside and there isn’t an interior door frame so I’ll use this as a template to paint and/or plank the interior door detail. 
Leave a Reply