Skip to toolbar
3D Wolsung Terrain (spring cleaning challenge 2023)

3D Wolsung Terrain (spring cleaning challenge 2023)

Supported by (Turn Off)

Steering wheel

Tutoring 2
Skill 2
Idea 2
No Comments
As i am waiting for a 16 hour print to finish, i created the steering wheel for my air ship.As i am waiting for a 16 hour print to finish, i created the steering wheel for my air ship.

I basically created 2 cylinders one for the yoke and the other for the body. i rotated the 1mm x 1mm x 24 mm yoke 90 degrees and center it with the body as you will see i was not quite center top to bottom and as i copy the yoke and rotated it 22.5 degrees it was off center.  The next step was to create the center point of my steering wheel.  The wheel is done  for now next i created the the podium using a cylinder base and proceed to remove various shapes to create a design i liked.  Lastly i added the center axis and did a test print for size.

I am happy with the size and went back to correct my centering issue.

I also added some detail to my steering wheel. time for another print.I also added some detail to my steering wheel. time for another print.
Nice :).Nice :).

Leave a Reply

Supported by (Turn Off)