OnTableTop – Home of Beasts of War

Reply To: [unofficial weekender] Boutique minis, old videos and a dungeon crawler

March 9, 2023 at 7:14 pm #1806083

guillotine

16041xp

@blinky465, it’s both good and bad. I have days when I sit 7 hours in meetings, but at least they’re all remote!

Right now it’s hard to disagree with @sundancer on the 3D printers… Just had a failed print and had to clean the tank. I hate that bit. To be fair though, that was the first failed print in months and could have been avoided if I had paid more attention with the supports. But still.

I feel mechanically the modern resin printers aren’t million miles from “set and forget”. The biggest problems are in the slicer software and/or quality of available pre-supported files. Most of the time pre-supported files need at minimum adjustments or having to do the supports yourself. Its a all doable and the slicers have improved much, but it is still very time consuming.