OnTableTop – Home of Beasts of War

Reply To: What went wrong here?

April 20, 2022 at 9:27 am #1731207

darkvoivod

7112xp

Thanks, I have just replaced the FEP, but other prints came out fine.
Those where either pre-supported or files I had allready succesfully printed.

I played around with the angles a bit. I think I found the sollution. I’ve been a bit impatient and did not want to angle the model in such a way it would add an hour or more to my print time. But I now think a flat model such as this just creates to much suction this way and pulls away from the printplate.
I’ve tried a new angle. now only starting to build supports when I see hardly to any red that needs supporting.
I have now succesfully printed this model, using less supports too.
This is more time consuming in one print, but not as much as failed print.
Saves on resin and clean up too, so overal: good learning experience.