Edo Strider for Counterblast™
Test Printing the Parts
Once the parts have been exported from ZBrush I set them up to run a test batch to make sure all of the parts fit properly and the details showed correctly. I could also check the fit of the clear window dome for the cockpit. Since these were already manufactured as clear injection styrene parts, I needed to make sure they sit properly on the hull.
This also allowed me to assemble the printed parts and check the scale. It turned out to be an impressive model for the tabletop at over 7.5″ (19cm) tall!
Next up I will be setting up the parts on sprues to facilitate making the silicone moulds.
Leave a Reply