Skip to toolbar
Wilco's Mass Battle Rules mk2 (Spring Clean Challenge 2021)

Wilco's Mass Battle Rules mk2 (Spring Clean Challenge 2021)

Supported by (Turn Off)

Printing my mk2 Armies!

Tutoring 8
Skill 9
Idea 9
No Comments

The boost that has made me look at this project again was seeing the great 3D files being made by Forest Dragon.

https://www.patreon.com/forestdragon/posts

There miniatures are a heroic looking 10mm, dude ranked STL Files designed to fit on 20mm x 40mm Baces. This is what I have been wanting for one time, the ability to obtain a large ranked force at low cost and in amazing detail. So I joined the Patreon. 

For Printing I’m using a Anycubic Photon Mono and a Anycubic Wash and Cure Machine. I can very much recommend the Printer and once I was printing of lots of prints I recommend if you can to pic up the Wash and Cure 2.0 as well as it will keep the cleaning of your 3D files contained and reduces the mess that can result from Resin Bath 3D Printing in general.

To be honest I don’t know how many minis have been printed over the last month but I will be ordering 200 baces and I am not even shore if that is going to be enough.

Messy Day 1 of Printing but Day 2 I tidied them up and printed the same about again.

I have been printing as my two game play test armies are Forest Dragons, Chivalric Knights and Vampires.   

 

Leave a Reply

Supported by (Turn Off)