Skip to toolbar
Capturing Old School D&D in a Statue

Capturing Old School D&D in a Statue

Supported by (Turn Off)

Priming the Statue

Tutoring 9
Skill 9
Idea 9
No Comments

I glued the arm to the standing adventurer before tacking the two thieves in place. I wanted the primer to layout the base of OSL.  This is going to be from three light sources in the front with the brazier in the statue’s lap being the most prominent.  I began with a solid black spray prime over the entire figure.  Next was a grey at about 45 degrees above and almost entirely from the front.  Last was white spray primer directly from the front, centered on the flames.  Not a bad start.

Priming the Statue
Priming the Statue
Priming the Statue
Priming the Statue

Leave a Reply

Supported by (Turn Off)