Romano-British for Dux Britanniarum

There are a lot of very good manufacturers that produce miniatures for the Fifth and Sixth Centuries AD, but for this project I decided that the Late Roman range from Footsore Miniatures was what I wanted.  They are probably a little bit better equipped than the unfortunate Romano-British actually were, but I’m prepared to sacrifice an element of realism to obtain some figures that I think will look suitably heroic on the tabletop.

The last Group that I completed was the first Group of Milites, so I’ve decided to start the second.

The miniatures are good quality and don’t require much in the way of clean up.  Flash and mould lines appear in obvious places and are easy to remove.

One point of note is that Footsore don’t cast their figures with spears, so it’s necessary to use a pin-vice to drill a hole in the weapon hand.  This is fairly straightforward once you get the hang of it.  There is an obvious point where you start drilling into the fist.  I found it easiest to go about three-quarters of the way on one side, and then swap and complete it from the other.  I then inserted spears made of steel wire and secured them in place with superglue.  Be sure to match the diameter of your drill closely with the diameter of your spears, otherwise the fit will be too loose.  The steel spears are available from Footsore.  There was a period over lockdown when they were out of stock, but they now seem to be available again.

I decided for this project to attach the figures to their bases before priming and painting.  This probably wouldn’t work for a game involving element basing, but for something like Dux Britanniarum which focuses on individual figures, it works well.  I’m using 2p-sized bases, with the figures superglued and then secured in place using Vallejo Acrylic Ground Texture, specifically the Rough White Pumice variety.  I’ve not seen many other people do this, but for me the main advantage is that is secures the miniature to the base and, in my opinion, paints up very well.  It can be a bit fiddly and messy to apply, but I’ve found that the same applies to PVA and sand.

I’ve also covered a sabot base in the same Ground Texture and will be painting that at the same time that I paint the bases on the miniatures.