Red Rocket 3D Printed
Fixing the Un-fixable
Despite my best efforts I have not been able to get the Girder B to print without failing.
There are two options here.
First is to continue on in the hope that it will eventually print out.
The second, find a work around and here it is…
I have decided that in order to progress with this build I would print the upper section out separately, then glue them together.
I will go into details in the next post As I will be using the same technique to print the roof sections and assemble them.
I have, however, not been idle, below are the Billboards.
As mentioned before, these are Available from Printable Scenery.
Two of these were printed in a 0.25mm layer height and scaled to fit the Printed Billboard Posters.
I have also Started Printing the Roof Sections and I will follow with another blog in a few days time.
I haven’t forgotten the Red Rocket Signs, I will return to them later on.
Until next time folks.
Leave a Reply