Manda's (Amachan) 3D Printing Adventures
The first tests.
I did a lot of experiments last night trying to figure out how things worked and what settings work for me. I am using a water washable resin from eSUN as getting IPA at the moment is either difficult or expensive.
I figured out that the following cleaning and curing process works well for me. After the print I get the print off the bed and into some warm water, I agitate that around a bit and let it sit for 5-10 minutes. I then get the little basket out that I use for cleaning with the prints inside and change the water to clean cold water. I then put my UV lamp on top for roughly 10 more minutes and then let them dry in the air and they come out really clean and solid. As you can see on the hex bases for an upcoming project.
I will be printing my first miniatures today.
I got my test files from the link below. I used the “3D Printer Calibration Matrix from Thingiverse” and the “FormLab’s Formtest STL”.
Leave a Reply