OnTableTop – Home of Beasts of War

Reply To: Layer issues with Anycubic I3 Mega – Any advice welcomed

March 18, 2020 at 10:48 am #1497891

blinky465

17028xp

Firstly, check your slicer settings.

A quick-and-dirty way of solving most bed adhesion issues (if it’s only a single layer height, for example) is copious amounts of pritt stick on the bed. I have a Tronxy X3 with bed level detection, but even that would (on a rare occasion) give me problems with one corner peeling mid-way through the print.

Since smearing the bed with pritt stick before printing, I’ve never had a problem.

(though your model will really, really stick to the bed – the pritt stick only needs be applied every now and again, not every time, unless you fastidiously clean your bed with alcohol between every single print)